Posted by GeneMO on January 27, 2009 at 21:56:22 from (216.74.221.70):
I was rebuilding the throttle (governor control lever) on my M. After putting a little spot of weld on the lever to build up the "tooth". I then filed it down to fit in the notches. The spring is broken and I got several tips on this board on where to get a new spring, or make one from a bicycle spoke. Anyway the shaft that the lever rotates on and the lever were worn. I was trying to think of something to make a bushing out of. I had been to a firing range a few days before and picked up some fired .40 S&W cases. Come to find out it was the exact right size. I cut the case head off, and slipped it over the shaft and it was almost a perfect fit. It is thicker near the head, so experiment to see how it fits better. It's brass, so it should make a pretty fair bushing, and it tightned the trottle lever up.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.