Posted by Jim Allen on January 27, 2009 at 12:07:25 from (209.173.160.22):
In Reply to: 706D Exhaust Slobber posted by wicksfield on January 27, 2009 at 11:13:38:
My 826 with a German D358 does the same thing. They are very low compression, direct injected diesel engines with an efficient cooling system and they don't generate much heat at idle. When combustion temp gets too low, incomplete combustion occurs and slobbering begins. He's letting it run too cool and idle too long. While its doing the slobbering, it's also washing down the cylinder walls and diluting the oil. My policy now is:
1) In cold weather, never start (if you can, mine won't start very well starting at about 40F, even with ether, and at 30, fuggedaboutit) without the block heater run for at least an hour. I avoid startup until I know the tractor is going to be used very soon.
2) Minimize idling. It won't warm up much idling anyway and it won't stay warm enough not to slobber unless it's a very hot day. My tractor is either working or shut off.
3) If you must idle, keep it at about 1000 revs. Doesn't slobber much at that speed plus it generates a little more heat. Item 2 takes priority with me but after hard pulls, I let it idle a little to cool off before I shut down.
4) Make sure the thermostat is installed and working.
5) Install a block heater.
The results of this policy for me has been a drastic reduction in oil consumption (which is, in part, a byproduct of diluted fuel), much better oil analysis results (ZERO fuel dilution!) and less fuel used because it's either working or shut off. Anyway, through trial, error and good advice from the gang at YT, this is what has worked for me.
I should also add that my engine has 8300 hours. It's tired but still runs well. I now use no more than about 1-2 quarts per season, compared to 6 or 7 at purchase 4 years ago. I also changed from SAE 30 Case IH oil to 15W40 Rotella-T and the viscosity change accounts for some of the reduction.
This post was edited by Jim Allen at 12:14:37 01/27/09 2 times.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
