Posted by karl f on January 22, 2009 at 20:08:37 from (172.130.12.223):
After reading post after post of wobbly shift on the large frame and jammed gears on small frame (656/666/686), I wonder how many people are shifing with the correct motion?
I would not be surprised if sometime in the tractor"s past someone was shifting hard in a diagonal motion.
Our 656 was owned since new (6300hrs) and still shifts nice and crisp sideways betwen gates, although a little loose within each fore and aft throw (r-1, 2-3, 4-5). I think we all have shifted it in 2 or 3 seperate motions, prolonging the shift mechanism.
The 1256 was purchased used with about 7000 hours on it, the shift was wobbled out in the levers and quadrant (dash parts) and got progressively worse in 15 years, where the range lever would flop around while the trans was actually in gear, and you could put it in forward and reverse at the same time. I put better used parts in it and it is much better now.
although different designs, my experience still leads me to believe that improper shifting technique causes a lot of shift problems.
When you get your shifters rebuilt, make sure you are shifting in deliberate motions in each direction needed to reach the desired gear so that you won"t have to rebuild the shift in a long long time.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Rescue of a Fordson F - by Anthony West. Introduction I live in the UK and have for many years restored Fordson tractors (in the main model N's). I have also restored and shown model F's, E 27N's, Field Marshall Series 2, David Brown Cropmasters and the old rey Fergeson T 20. At one time I had seven restored examples which were shown and used in ploughing matches. As most restorers, I have a number of war stories I can relate on a range of topics that may help other like minded and interested people. Perhaps my first p
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
