Posted by Janicholson on January 22, 2009 at 18:14:17 from (68.112.156.69):
In Reply to: 1941 Farmall H posted by IH Country Boy on January 22, 2009 at 17:48:29:
There are four seals that could leak into that space. In order of probable: Transmission countershaft to Liftall drive shaft. Transmission input shaft. Liftall pump input shaft fitting. Rear main seal on engine. If it rear end 90wt gear oil it will smell sulfery and strong. If it is, it is (probably) the seal on the countershaft. Drain rearend oil. Remove the Liftall.(heavy and a floor jack is a good idea.) Use a solid hard square shanked tool to remove the drive coupling. Lefty loosy and very tight. Remove the fasteners, replace seal. If that seal looks good, (and it is stinky gear oil) it is the trans input shaft seal. Same as above, but instead of removing the coupler disk, remove the clutch shaft, and front trans input seal flange. Replace seal. If it is engine oily stuff, but pretty clean, it is the Lift all seal. As above, but remove the liftall drive coupling from the Liftall, and replace seal. A brass drift is placed into the gears of the pump to lock it for turning the disk, lefty loosy. If it is engine oil, Usually darker. (matches a sample on white paper from the check cocks.) pulling the tractor apart, and replacing the rear main seal (and clutch pilot bearing and T/O bearing for insurance against doing it again soon) The process is more involved and both the archives "search For" box, and responses to your questions will get you through it. The plate with 6 bolts is not a oil reservoir, taking it off will not dump massive oil. It will be grubby. JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
