Posted by steve midcoast on January 21, 2009 at 17:24:32 from (69.39.100.20):
Putting a later cub low boy engine into my father in laws 48 cub..Noticed a difference where the hydraulic lines go into the front of the block...Coming off the block on the early engine there is an adapter that the two lines bolt into. The adapter is held on with 4 bolts roughly at positions 11 o clock, 1 o clock , and 5 and 7 o clock. The block is threaded in these 4 positions to accept these bolts. The newer cub engine has holes only at the 11 and 5 o clock positions.(this engine did not come with the adapter, so we need to mount the old adapter to the new block) Has anyone done this conversion and just used the 2 bolts to hold on what originally was held on with 4? Or do we need to drill and tap 2 additional holes to mount the adapter that the two lines bolt to? Any info appreciated.thanks.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
