Posted by Janicholson on January 20, 2009 at 07:13:26 from (199.17.6.128):
In Reply to: t/a transmission posted by william shafer on January 20, 2009 at 05:47:15:
This applies only to the mechanical TA, not hydraulic controlled later TA systems. The OR clutch is designed to allow the whole TA assembly to rotate as a unit in the direction of engine rotation when the TA disk clutch is locked up (engaged) this is direct drive. The power goes from the engine clutch to the TA planetary gears and body of the TA gearbox. This rotation (because the TA disk clutch is locked) drives the housing and gears at the same time. At this time the OR clutch internals are riding along doing nothing.
When the TA lever is pulled back, it releases the TA disk clutch. This allows the TA planetary gears and gear housing to be free from one another. This causws the TA housing to try to turn opposite to the engine direction. The Overrunning clutch stops this motion, transferring the reduction reaction torque to the transmission housing at the rear of the TA.
A parallel to this story is a drill screwdriver attachment that was popular before variable speed drills and cordless reversable drills. It was a fist sized speed reducer and bit holder with two split sections that the operator was to grab with fingers to make the driver turn either forward, or reverse, with much slower speed than the drill motor, and controllable force. Its operation in the forward direction (driving screws) used fingers as the one way clutch, absorbing torque reaction from its internal planetary gears. Also imagine a regular pickup truck stick shift with all the mounting bolts and cross member mounts removed. If put in gear, and the clutch let out, the gear box would rotate, and the PU would not move. I hope this works as an explanation. Kevin Meier on this forum, and many others can supply rebuild parts, rebuilt units, heavy duty units, and advice. There are videos available here as well. JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
