Farmall & IHC Tractors Discussion Board |
Re: Farmall 300 brakes
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by RAW inIA on April 02, 2000 at 18:30:17 from (206.28.170.217):
In Reply to: Farmall 300 brakes posted by Milt on April 01, 2000 at 19:59:42:
Take the brake cover off an you will find aocuple of fiber discs that fit on a splined shaft. Between these discs are acouple of steel discs with springs holding them together. If you take these apart, there are some bsteel balls between them in ramp like grooves. these have to be cleen and rust free. |After cleaning them we used to put a little never-seeze or other anti-seeze lubricant on them, but just a little. Clean out the brake chamber, and sannd the fiber disc surfaces llightly to take off the glaze. They then should work. Our 350 used to need this once or twice a year, depending on use. Used to accidently take off when balling with the left on locked on and didn't notice untill the next time we went to stop, then it almost threw the one on the wagon off the front. Also got the outside cover quite hot (black). Quite common with the early IH disk brakes.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|