Well, I had completely restored this tractor a few yrs ago, and put HEAVY cables on to accomodate the 6 v system. It has a 6v genny, cutout, and 4 position switch, (its a 40 H). The engine is top notch, new pistons, sleeves, ground crank and cam, completely rebuilt head. It just seems that lately, its not go the power to crank well. I took the battery and it tested good, the genny is still showing a good charge, and I ran all of the connections to make sure they were clean and tight. (took the cables loose, cleaned them, and put them back on tight on both ends of each) Still getting the same thing. It runs on a magneto that I had redone by Magman, and it runs fine on it, but it just doesn"t start like I think it should. If I disconnect the 6v and use a a 12v jump pack, it fires up in just a second. Its just getting a bit old and I was considering just switching the whole thing over to 12v to eliminate the problem as trying to find it is making my already thinning hair thin that much more.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.