Posted by Janicholson on December 30, 2008 at 13:36:24 from (68.112.156.69):
In Reply to: BN 12volt conversion? posted by Bilko on December 30, 2008 at 12:03:02:
Yes. Bob M wiring diagrams will do what you need. If it has a magneto ignition, things get a little harder, but not much. A mag is grounded to make it stop, and ungrounded to run. THus there is no voltage going to the mag at all, and cannot have any ever. So to make the alternator excite, I would use an oil pressure swithc fromNAPA to make it work The switch has two terminals, and is open when there is no pressure, closed when there is about 3 psi. This oil pressure switch is placed in series with the positive side from the battery. Run a #14 wire from the starter switch on the starter (big terminal attached to the battery cable) to the oil pressure sw, then to the #1 terminal of the Delco SI alternator. The #2 terminal attaches directly to the bigger output terminal of the alternator. The output terminal attaches with #10 wire to the terminal of the amp meter that is not connected to the battery pos post (usually at tha same place on the Starter sw that I refered to before. The wire just mentioned (from amp meter to battery at starter should have a fusable link wired into it near the start switch at the starter. NAPA has fusable links; they protect all systems from letting the smoke out. THe fuse link should be rated at 10 amps over the rating of the alternator you use. (often stamped into the alternator housing) A Hitachi alternator from a mid 80s nissan PU will be smaller and put out plenty It is wired similarly. THere are many descriptions of the Hitachi in the archives to use for terminal marks. Good luck
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
