Most times on that type seat the hole that piviot pin goes through in pipe is worn or broken. Fixed several by making a new pin and some welding. If you unbolt bracket from transmission cover and turn seat upside down you can see problem. Or move seat side to side bolted on tractor and you can see pipe roll in bracket some. If hole through pipe or bracket is very bad you can remove old material and weld a steel bushing into pipe with correct ID for pin. If holes are worn in holding bracket use bushing for oversize pin. If nothing is worn to bad just a oversize piviot pin with holes enlarged to match will work. Be sure to get hole in pipe centered or seat will lean. Also if no worries about removing again the piviot pin can be welded at ends on bracket and ground down smooth.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.