Posted by jonathan mirgon on December 24, 2008 at 20:48:40 from (207.69.139.133):
In Reply to: c123 governor posted by RDJ Farms on December 24, 2008 at 18:00:25:
If you did not mark it before you pulled it out then it would be next to impossibal to set it up right with out removing the front timing cover.There is a single punch mark on the camshaft which aligns with a single punch mark on the crankshaft, these would be uneffected. The double punch mark on the camshaft should align with the double punch mark on your governer gear. You may try sticking a flexibal mirror through the governer housing hole and rotating the engine until you know where these marks are and then reinstalling the governer drive gear. If that does not work than you will need to remove the front timing cover. I have pulled several of these engines apart for rebuild and found these marks not aligned and the governer did seem to function fine. But to do it properly punch marks should line up with each other.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
