Posted by Janicholson on December 21, 2008 at 16:27:04 from (64.83.205.193):
In Reply to: Farmall M won't run posted by George in Nebr on December 21, 2008 at 16:10:29:
There are three ingredients to operation. The first is fuel and second is air, third is spark. If it starts it is getting spark (initially) if it starts it is getting fuel and air, So really one of these itams is leaving. immediatly after starting. There should be a fuel shutoff and glass sediment bowl under the tank. There should be a fuel strainer screen in the inlet fitting to the carb (is it clean). There should be no other filter. If there is, remove it, and put a piece of rubber hose in its place (should be steel lines there for safety) Does the ignition stop working when it quits? Pull the coil wire, or mag high voltage lead and hold it about 3/16 or 1/4 inch from the block and have someone crank it (be safe, block wheels, and set brakes). No spark, needs to be diagnosed further, Possible condenser, or Coil fault. JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.