Posted by Andy Motteberg on December 17, 2008 at 19:53:08 from (4.143.223.8):
In Reply to: More H questions posted by Farmallb on December 17, 2008 at 19:29:41:
The brakes should not drag and should not have an excessive free movement of the pedals before they take hold. Pedals should have a free movement of 1-1/2"; measurement to be taken between the points of contact of the brake pedal arms with the top of the rear frame cover, or just enough movement so that when just a slight pressure is applied on the brake pedals, the brake lock can be dropped into the first notch in the rack of the left-hand brake pedal arm. To adjust the brakes, screw in the set screw in the bottom of the brake drum cover as far as it will go, then back off one quarter to one-half turn and lock it. Obtain the correct free pedal movement by changing the length of the brake rod by removing the pin from the clevis, loosening the jam nut and turning the clevis either to the right or to the left. To obtain equalization of both brakee, it is very important that both brake pedals have the same amount of free movement. A definite way to check the equalization of the brakes is to jack up both rear wheels so they will turn freely, block the tractor securely and latchthe brake pedals together; then start the engine. Shift the gears to 3rd or 4th speed and engage the clutch; while the wheels are turning, apply the brakes Application of the brakes should slow down both wheels at the same time and also tend to reduce the speed of the engine. If one wheel stops and the other one continues to revolve when the brakes are applied, loosen the adjustment on the wheel that stops just enough so that both wheels stop simultaneously when the brakes are applied.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
