I don't completely agree with Gary and Andy. Over the years I've taken two loaders from Utilities and mounted them on Farmalls. I'll use 300 as an example. Distance from rear axle carrier to front of front bolster, is within 2" between Farmall and Utility. The front bolster is the same height in relation to the axle carrier. The basic difference is height of entire tractor off the ground, usually around 3". Both loaders I changed, had no problem lowering below ground level.
The 340 is shorter than 300, but so is the H shorter than a 300. My dad had to add 3" to axle mounts of a No.31 loader going from H to a Farmall 300, in order for loader cross member to clear the narrow front tires.
I think your biggest problem may be hydraulics, photos weren't clear enough, however I think your looking at a loader with hydraulic bucket requiring two remote valves. Does your H have that type of hydraulics? You might want to check that one out. It could get expensive, especially if you want live hydraulics.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Engine Rebuild Kit - by Curtis Von Fange. I always liked engine rebuild kits. They have all the replacement parts for overhauling an engine without going to the store to get gaskets, special measuring tools, or miscellaneous parts. They come neatly packaged, clean and tidy. But it's important not to let that packaging lull you into a false sense of security. The appearance of matching sleeves, pistons, rings, and bearings can cause frustration and agony if not properly measured and installed in a workshop environment. Following c
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.