Posted by ScottyHOMEy on December 11, 2008 at 22:02:38 from (71.241.208.102):
In Reply to: Re: lAA farmall posted by Trent O on December 11, 2008 at 19:50:38:
in the hood. . .
It sounds like this might have originally been a dual fuel tractor -- started on gas and switched over to distillate once it was warmed up.
Gas only would have three holes in the hood -- exhaust, air breather and the gas tank. Dual-fuel would have had exhaust, air, a cap for the main fuel (distillate) tank, and another cap for the smaller gas (starting) tank. Either case, these are apart from the radiator cap which passes through the top of the grille.
There would be some collectibility to the dual fuel IF all the components of the whole system are there -- both fuel tanks and the manifold, which was different, and the radiator shutters, used to reduce the efficiency of the fan and radiator, to allow the distillate to run the enigine up to a hotter temp)
The manifolds on the dual-fuels had a heat shield around them with an adjustable shutter to regulate air flow, allowing it to heat up more when burning distillate. Many of them rusted shut or rusted out and were replaced. If you have one, it's worth keeping and cleaning up to see if you can make it work.
If you've got both tanks, they are definitely worth keeping, but plan on running gas in both, or treating the small starting gas as an empty object of interest. There's nothing around that is what the old distillate fuel was and most folks long ago started running gas in both tanks.
Shutters are a nice touch and still quite useful fror warming up you engine on short runs, especially in a cold climate.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
