OK John, this may make your eyes hurt but this is the way I do it. After my pic is in My Pictures or My Documents I go to the left side to Galleries. Follow the directions to upload your pic. Others use Photo bucket or other hosting sites. Let,s say you got the pic uploaded. Get the pic on your screen and RIGHT click on the picture. LEFT click on properties. Highlight by putting the cursor on the URL and holding the LEFT mouse button down while dragging untill all of the URL is highlighted. Then RIGHT click on the highlighted URL then COPY. Now go to the forum and start a new topic (or reply to one). After finishing your post LEFT click the Img box on the upper right. Move your curser to the right where [Img] shows in your post and RIGHT click. LEFT click PASTE and that should do it. Hope I have my LEFT and RIGHT clicks correct. Try It. I uploaded this one to the Community Album. David.......PS I just know enough about computers to be dangerous.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
