Posted by Chris NW Ind on November 13, 2008 at 16:24:03 from (64.136.26.226):
Snapped this pic of my big guns all lined up and ready for winter. I spent part of yesterday and all of today getting the 450 gas squared away and that was supposed to be sure starter.
First of all, she fired once and then absolutely refused to start. After an hour of messing around and determining that I had a fuel problem, I remember dumping fuel in the tank from my W9. I thought the fuel was OK, but it clearly was not. Drained a few gallons off the bottom of tank and she fired right up.
Then, I drove her a couple hundred feet to air up a low tire and saw that the deck covered with hydraulic oil. Turned out the o-rings for the pump pressure/supply lines had failed. Not only did I replaced the o-ring, I replaced the pump lines that had rubber hoses (which were also leaking), with solid steel lines. Maybe not the best choice, but I did have a good set sitting around.
Once I got the hydraulics put back together, the power steering refused to work. It would sort of work if I moved the valve levers. I had to reposition the single/double-acting selector. Two of valves have broken off roll pins for the detents. I ought to fix that.
Works like a charm now. And I killed 3 birds with 1 stone. Fixed 2 hydraulic leaks (actually 3), and the hydraulics don't feel like they're getting super hot.
Anyway, here's the 450 Gas, 560 Gas, W-9, and my buddy's JD 4010 Gas
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
