Wild Bill, Im not sure what exact Mag youre dealing with, but on many mags where the rotor tip is just prior to when the impulse spring winds up n then trips IS NOT DEAD LINED UP WITH THE TERMINAL TO WHICH ITS GOING TO DELIVER A SPARK JUST SHORTLY AFTERWARDS (its physically located JUST BEFORE the place where it will be after/when the spring trips) ...... Theres no spark until the impulse trips, and when it does the rotor tip ONLY THEN passes by that correct terminal so the saprk jumps from the rotor tip to the caps terminal. I AM FAMILAIR with the Wico C and X (NOT XHD) Mags used on Two Cylinder Deeres and to time them as I say the rotor tip IS NOT where its going to be AFTER the spring has wound up n then tripped.
I time them (Wico C and X used on Deeres) to the point the mag trips/impulses/snaps right as the No 1 piston is at TDC and prior to snapping/tripping the rotor tip is JUST BEFORE the upcoming No 1 cyliners inner cap terminal. One can first RETARD THE TIMING, then get the piston to TDC, then slowlyyyyyyyyyy advance the timing just to where she snaps/trips
Hope this helps even though Im not familiar with your particular mag, let us know
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
