Posted by John T on November 07, 2008 at 09:30:10 from (66.244.97.31):
In Reply to: Re: 6 volt charge posted by bcarter2 on November 07, 2008 at 06:27:23:
The charging amps depends first on what genny it is, Im NOT familiar with IHC but many of the older 3 brush units didnt put out much over 10 amps and even the later 2 brush units that used a Voltage Regulator were maybe 20 amps max. That being said with your older 6 volt unit Id expect maybe 5 to 10 amps charge right after a start up and then back down to 5 and under depending on if its set at Low or High Charge and your RPM
As far as converting to a full fledged Voltage Regulator they have an advantage in that the charge rate is automatically controlled by the VR versus a Low or High Charge light switch, but its NOT original and more expensive, I dont see any pressing need to convert if all you need is a new cutout relay assuming you have a good working LHBD combination light and charge control (Low or High charge) switch. Also a VR dont cause it to charge at any higher rate the it would using a LHBD switch if it has a good proper ground.
That LHBD switch wires to the gennys FLD post and provides the gennys Field ground so it needs a good ground itself to make her charge. When running at fast RPM momentarily ground the gennys FLD post dead to ground n see how she charges then?? If it does then but not otherwise the switch is bad or not well grounded or the wires bad from gennys FLD post up to the switch
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
