Rich: For 150 horsepower, I want 6 tires on the ground, 8 would be better. Sure we can load these tractors with chloride and wheel weights until there is no slippage, and they will pull, but what is it doing to soil, tires and power train. When I talk efficiency on tractors, I think they should last 30,000 hours
Conventional two wheel drive tractors have traditionally excerted drawbar pulls roughly 2.5 to 3 times their own weight. Some of the articulateds are pulling 6 times their own weight. You increase that ratio greatly with floatation tires, dual tires be it 2, 4, 6 or 8 tires.
My 1066 was delivered to me new on 20.8x38 singles, loaded to the limit with chloride. I had two complaints; 1. Tires were toast within 1,000 hours. 2. On my 24' cultivator the tractor left wheel tracks the cultivator could not smooth out. I disliked very much trying to plant or drill a uniform depth on that surface. One could also see the crop did not do as well in those wheel tracks.
The second year I installed 4 new 20.8x38 same brand tires, no chloride, no wheel weights. Those 4 tires lasted 9,000 hours. The tractor actually pulled the cultivator or my 88 blade Bush Hog disk easier than with single tires and weight. Gone were those annoying wheel tracks to plant or drill over. Also gone was the noticable less crop in those wheel tracks.
We've now gone to 42" and 46" tires putting even more rubber on the ground. I've driven 3 of the 300 hp articulateds, 2 Deeres and one NH. 20.8x42 duals. I actually like the NH best, this surprised me as before the fact I figured Deere had the best tractor. Those machines will almost float. None of these tractors had any chloride. They do put rear wheel weights to insure both rear ends are getting close to same traction.
I'm not cncerned about which tractor or which wheel equipment will give the most drawbar pull. It's all about efficiency.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
