Posted by Janicholson on November 02, 2008 at 17:57:56 from (66.173.50.118):
In Reply to: Cultivators posted by TimWafer on November 02, 2008 at 17:14:39:
In a nutshell: The cultivators are effective on row crops, but pretty slow for today's field sizes. If you are playing with 10 acres or less they will do fine. Two levers with adjustment notches bolt to the front of the rear axle housing (we take off the drawbar first, i think most do because it is not possible to use the tractor for utility purposes with the cultivators on it ) Two pipes with metal brackets for the cylinders attach to the lever handles, one on each side. S shaped steel bars with a cross pin in one end go in the holes in the bottom of the hydraulic pump, to guide the cylinders. On the front cultivators there is a 4"X4" angle iron that crosses in front of the bolster just below the grill it is attached to a pair of plates bolted to the front bolster casting, one on each side. The pipes mentioned push on the top of the cultivators on each side to raise them. The rear unit covers the wheel tracks, and tills the middle of the row where the front tires run. There is also an accessory tined rake like smoother that is used on the back to break up ridges, but if it is not there, no problem. it takes two people about an hour and a half to do it when they know how, it will take three or more if it is the first time. Be careful driving into the setup not to puncture a sidewall on the front tires on the sweeps Shields for preventing the sweeps from covering seedlings are valuable. The cylinders are connected to the front hydraulic ports on either side. Good luck, They work but seem like a Rube Goldberg affair. JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
