Posted by charles todd on November 02, 2008 at 14:09:32 from (205.242.95.136):
In Reply to: SA Landscape Rake posted by Doug Kieta on November 02, 2008 at 10:03:19:
If your SA has some sort of rear lift (I am igonrant on smaller IH tractors, but know a little) fabricate a mount that accepts a 3 point attachment.
Another thing you can do is to fabricate a pull trailer that has a 3 point type lift assembly hooked to an electric linear actuator. This can be ran from the SA 12VDC and hooked to a 3 position momentary ON-OFF-ON switch. This switch will be like your lift control on a tractor with 3 point.
I have see the trailer type used behind trucks and 4 wheelers to use small 3 point attachments like disks, blades, and the such. I am sure if you are good at using GOOGLE, you can find pictures of these.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.