Posted by Bob M on October 28, 2008 at 11:49:22 from (151.190.254.108):
In Reply to: Re: Dist interchange posted by Farmall A on October 28, 2008 at 10:21:54:
The magneto has no centrifugal advance - only a fixed ignition retard built into the impulse coupling. (It retards timing only at cranking speeds.) Therefore there are no centrifugal advance parts in a mag that can be transplanted into a distributor.
----
As JimN and NDS point an A distributor will work fine on an M. It might cause the M to develop just a tad less power - probably not enough less to notice however. It also MIGHT cause an increased tendency to backfire on a sudden throttle closure. But then so does the "correct" distributor as the advance parts wear - so it's really not a big deal.
If it were mine go ahead and use it...
----
A word of caution on your high voltage coil: The 40KV coil will indeed fire .040 plug gap. HOWEVER the distributor is designed for lower voltage (20KV or less). So long as the cap and rotor are in good shape and clean it'll work fine. But the HV coil and the wide plug gap may result in arcing inside the cap (and consequential misfiring) as the cap ages, accumulates internal dust and moisture, etc. Bottom line is you may be better off using a conventional coil and standard plug gap with your electronic ignition.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.