Posted by mkirsch on October 24, 2008 at 10:23:11 from (64.80.108.53):
In Reply to: IH 80 snowblower posted by 300winchester on October 24, 2008 at 09:03:01:
Why does it need to be so long?
Where'd you read that you needed a special PTO shaft? Maybe for a particular snowblower that used a shaft designed specifically for that blower, but not as a general rule.
You need a shaft that:
1. Is long enough.
2. Is rated for at least as much HP as the snowblower is designed to be used with.
3. Has the proper ends to fit the shaft on the blower and the shaft on the tractor.
4. Has a slip clutch, if your existing shaft has a slip clutch installed already.
Your best shot at getting the right combination of parts is to go to an equipment dealer that has an assortment of PTO shaft components that can be assembled into whatever shaft is desired. They may even be able to re-use your existing front and rear yokes, which will save you money especially if the rear yoke has a slip clutch built in.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.