Posted by Paul in MN on October 23, 2008 at 20:26:23 from (71.210.155.40):
In Reply to: Engine rebuild posted by Tom Windsor on October 23, 2008 at 19:17:07:
This may be just a bit of "mis-speak". But the #1 wire is always connected to the #1 spark plug, no matter where the piston and crankshaft are. What is significant is that the magneto rotor (or distributor rotor) is aimed at the #1 plug wire terminal of the dist cap when the #1 piston is at TDC of the compression stroke (meaning both valves are closed).
On a rebuilt engine, it will start with the spark being retarded (firing after TDC), but it almost impossible to start with the spark before TDC. Reason is that the premature firing of the gas mixture is trying to push the piston down before it has hit the top of its stroke, thus the engine is trying to start by running backwards while the starter trys to turn it forward.
After you get it running, then you can "dial in" the spark timing with a timing light (if the engine has timing marks). Some of the old timers can set the correct timing "by ear" by listening to how the engine is running. I never got that merit badge.
The governor on a gas engine doesn't care what the timing is. It is responding to the engine RPM.
Maybe this is what you were already thinking??
Have you thought about how to spin the oil pump before starting it? Does the oil pump on this engine need to be primed?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.