Posted by Dan in North Houston on October 14, 2008 at 12:23:37 from (98.200.150.196):
In Reply to: Is it safe? posted by Mark W. on October 14, 2008 at 08:20:02:
Back in the 70's I worked on drilling rigs. We mostly had 4 to 6 Detroit Diesels (8V74 up to 12V92TA) but sometimes Caterpiller motors. It was standard procedure during oil changes to fill the crankcase up with diesel and run the motor for a few seconds, then drain and fill with motor oil. Those motors were run hard, probably about 20+ hours per day on average. Some days they ran full throttle all day except for being idled back a few minutes every hour or so when we made a pipe connection, and a brief shut-down to check the oil level every 12 hours at crew change. With what I know now, I wouldn't do this at all. However, it didn't seem to hurt them.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.