Posted by Janicholson on October 06, 2008 at 10:17:01 from (199.17.6.128):
In Reply to: Re: M Hydraulics posted by b OLSON on October 06, 2008 at 01:18:09:
Then I would block up the loader so that all weight is on the bucket (On a plank or 4X4 or two), and the bucket cylinder is also not under load. I would remove one of the lift cylinders, and lay it so the hose connection is highest, and the cylinder is lower to the other end. Then I woule operate the lift lever to extend that cylinder. Then I would put it in the Lower position with the engine off, and manually push the cylinder in to its shortest length while keeping it low on the ram end (not past the shiny part of the ram, just to where it normally goes. I would do this several times, then check and refill the resivoir. Then I would reattach the first, and do it to the other side the same way. Again check the fluid level. Re-attach and try it. I would also check the tilt cylinder for air in a similar manor, Both ends if needed. This is an open center system, and (I assume you wire back the main lift rod to use different spool valves) if you attach a third valve to the return hose going to the reservoir that must also be a open center valve with its return line attached to the reservoir. Good luck, air can be troublesome to remove. JimN
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.