Posted by Eric Bergstrom on September 24, 2008 at 08:14:02 from (68.115.89.201):
In Reply to: W4 rear axle seals posted by RVS on September 24, 2008 at 06:02:24:
Wow, that's a cool 4H project! My dad and I restored a W4 a couple years ago and had to do the same thing. It was easily the most difficult part of the project.
First we put the tractor on blocks, removed the rear wheels, and drained the rear end. Then we took off the PTO and disconnected the rear axles from the bull gears (it's just one bolt per axle). At that point we were down to the axels and cast iron hubs. They are HEAVY and I would advise using a cherry picker to move them.
We then heated and cooled the hub, used penetrating oil, and put it in a big press, but nothing would budge ours.
We ended up having to screw a bolt all the way into the end of the axle and pound on it with a sledge hammer. We dug a hole in the ground and put a railroad tie on either side of the hole so the hub could rest on it with the axle hanging down in the hole. We then pounded the axle through.
This system worked, but it was not ideal. 1.) The axles fought us the whole way 2.) You need to be accurate with your swings so you don't mark up the cast iron hub. 3.) It's difficult to find something to use as a punch once the end of the axle has moved down inside the hub. 4.) We made it injury free, but any time you're making that much metal collide, it can present safety issues. BE SURE to wear safety glasses, etc. if you attempt this.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
