Posted by P and R Pete on September 23, 2008 at 11:08:29 from (205.238.236.103):
In Reply to: Farmall A clutch problem posted by john in pennsylvania on September 23, 2008 at 07:23:06:
John, just in case you've never adjusted your clutch yet, here's a picture from my Super-A, where the adjustment is done. The inspection hole is at the rear of the torque tube, underneath. (I'm trusting that the A and SA are the same)
#1 is the yoke attached to the brake pedal, and it's 'horseshoe'-shaped, and loops up and over the nuts and threaded rod and down again, and is all one piece.
At #2, there is a hole in the yoke which is NOT threaded, (much as it may look like it is), and is there so that the threaded rod can move back and through the yoke.
#3 are the two nuts that do the adjusting. The pedal pushes the rod forward, which pushes the throwout bearing forward to engage on the clutch. So if your clutch is already too tight, you have to work those nuts to get the rod to move rearward a sufficient amount to get an inch of freeplay at the pedal, like Dave already said.
If I don't have this bass-ackward (LOL), loosening the right nut, and 'tightening' the left nut will pull the rod rearward. When you have it right, re-tightening the right nut will lock the adjustment.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.