Posted by ScottyHOMEy on September 16, 2008 at 10:57:47 from (71.241.213.150):
In Reply to: Farmall A Getting Hot posted by astimpson1 on September 16, 2008 at 09:30:53:
No way to tell safely without removing the grill so you can get your hand on it but it sounds to me like it's working just the way it's supposed to.
Yours is a non-pressurized thermosiphon system and does not (or at least should not) have a thermostat, nor a water pump. Works on the basic principle that heat rises. Your coolant heats up around the cylinder sleeves and in the head. As it heats it rises to the top and passes out the front of the head to the radiator. As it cools in the radiator it falls and re-enters the crankcase at the bottom. The rising in the motor and the falling in the radiator is what creates circulation in the system in the absence of a pump.
If you have a good muffler tightly clamped to the pipe, you'll notice at high RPMs that your fan is actually noisier than your exhaust. I know listening from the house to our BN (same motor) out cultivating that, except when the governor would cause her to belch, you never heard the exhaust. All you heard was the steady roar of the fan.
Point is that the fan is over-efficient for the size motor, which is what gets the thermosiphon circulation going. I've noted the same thing as you, that the top of the radiator will be hot while the bottom will be comfortable to the touch, even after a hard run, and even cool to the touch if she hasn't really been working hard. And that's with a clean, good working system.
Yes, it's different from automobiles, where we're accustomed to the whole system being under pressure and hot every where but, myself, what you describe sounds quite normal for a non-pressurized thermosiphon, so I'm not sure you have a problem.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
