Posted by Hugh MacKay on September 09, 2008 at 02:08:21 from (216.208.58.110):
In Reply to: Re: Leaking 140...??? posted by KRS_MED on September 08, 2008 at 18:30:23:
Keith: Check the hydraulic fluid level with both levers and front rockshafts in the rear position, (down if you prefer to call it that) and tractor not running. Fill to bottom of the filler plug. Before you put the plug back, start the tractor, and at low idle, operate the hydraulics through the full range several times. This will remove any air in the system, plus your certain it's not over full. If much air comes out during that you should shut tractor down and recheck fluid level.
The very best manual for you is the original IH operator's or owner's manual. Depending on tractor and year, it might be called either. Binder Books have the rights from CaseIH to reprint all these old manuals, and do a very good job of it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
