Farmall & IHC Tractors Discussion Board |
Re: Source for Tel-A-Depth Cable
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by MoosieDog on March 21, 2000 at 23:04:58 from (12.78.178.209):
In Reply to: Source for Tel-A-Depth Cable posted by Kent on March 21, 2000 at 03:34:26:
The cable to the rockshaft drive unit will take many calls to many tractor yards I believe. I think this cable was unique to the 240. On one of my 240's, I gave up and just by-passed the whole tele-depth with an auxilary control valve. If you're not plowing with yours, that will work just fine. Do you have the old or broken lateral swing shaft or lateral swing limiter (which one broke?)? If so, any good welder can fix or remake these parts. I've built several from scratch over the years. This is a really weak system on the 240s and failure is common. Consequently, junk parts are hard to come by. Bellcrank failure is also common and I finally figured out how to fabricate one of those, but it is quite a job of cut and paste. When you get it back together, I strongly suggest you use crossing chains to limit swing and take the load off the swing assembly or it will continue to fail.
Follow Ups:
Home
| Forums
Today's Featured Article -
Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|