Posted by PaulW_NJ on August 29, 2008 at 16:14:58 from (72.76.239.55):
Do the valve stems on the C123 engine (240 tractor) have two grooves?
After having the head redone on my 240 Utility, and ending up with oil spraying everywhere through the exhaust, I took the head back to the rebuilder to find out why the valve seals in the gasket kit were left off. The main reason is that there is a second groove in the stem of the new valves that were installed right in the place where the seal is supposed to ride. Hence there isn"t a good surface to seal against. Did they install the wrong valves during the rebuild? I know the factory head didn"t use valve seals, but is it possible to put them on?
When I pulled the rebuilt head there"s a puddle of unburned oil on top of all 4 pistons. I know the bottom end may still be the problem, but due to the quantity of oil getting by, the fact that there"s no blow-by into the crankcase or rocker case, and good compression data, the head is most suspect.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Picking Corn - by Rick Nikolich. It was the day before Christmas shutdown at work and I asked our lead engineering expert Scott Andrzejewski what he was going to do over the holidays. He said that he had some corn that he still needed to pick with an antique one-row New Idea corn picker. Scott has a nice farm about an hour north of Lansing in St. Johns, MI. He wanted to get the rest of his corn in by the next day (Christmas Eve). We had about an inch of new snow on the ground and single digit temperatures. So in the bac
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.