Posted by Doug -- Iowa on August 25, 2008 at 19:49:53 from (208.126.0.176):
I used the 706G on the round baler this past weekend with no issues, made 55 bales. Coming home I thought I noticed a bit of a miss but it's been known to foul a plug occasionally, so I didn't think much of it. Went to start it today and it fully misses on #2. Pulled plug and it is brownish gray, not fouled. Did compression check and #2 is 20 psi. I last checked compression during tuneup in March and it was 105. So....either a stuck valve or a hole in the piston. I'm hoping a valve - the tractor is supposed to have M&W pistons in it. Oil pressure holds well at 38 psi and temp runs just below 190.
Which one do you guys think it is going to be, valve or piston, before I open her up?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
