Posted by spencer13cat on August 18, 2008 at 15:11:57 from (75.12.158.180):
In Reply to: F-20 Fly wheel help posted by dave guest on August 16, 2008 at 20:46:44:
For future reference to newbie's.............................I used a similar set up. I used channel iron drilled 2 holes in one 8 1/4" on center and 1 hole in the other identicle to yours. I bought 3 grade eight bolts. The bolts are 5/8"-11 x 6" adjust your length based on cross barr thickness. Be sure to engage several threads before you put any torque on the set up. I put anti-seize on the threads and the washers where the bolts heads contact to prevent heat build up. As the fly wheel pulls off I had to re-adjust adding shims. After the few few turns I could finish pulling by using two of the bolts alternated about a turn at a time. Threaded rod would illiminate this but it is nowhere near grade eight in strength. The flywheel ends up almost flush with the bell housing before it is free. Depending on where you do this be careful. the standard F-20 flywheel weighs exactly 100lbs. Not a guess, I weighed it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
