Posted by PaulW_NJ on August 16, 2008 at 19:23:12 from (72.76.239.189):
I recently had the head from my 240U rebuilt by a reputable machine shop. New valves, seats, guides, springs. I bought the tractor last year, and while it hardly smoked at all,it ran very rough. I discovered it had a frozen intake valve, which had caused several bent valve push rods.
Here are the compression tests before the head rebuild. The first column is dry, the second after oil injected:
1 130 160 2 0 0 3 125 160 4 145 170
Just started it after the rebuild. The engine now smokes like a locomotive. Cars going past slow down to see where the fire is. Runs very smooth, but spraying unburned oil out of the stack. Everything is covered with droplets of unburned oil. Doesn"t smoke for first 30 seconds, but then smokes like crazy, idle and load. Plugs are wet, black,and very oily. Have only run engine for less that 15 minutes.
New compression tests:
1 115 130 2 120 130 3 135 145 4 138 145
Blow down test:
1 15% 2 15% 3 4% 4 10%
Why should it go from no smoke, to a serious smoking problem? Before I go back to the machinist, could the head gasket have somehow broken during installation? Anything else I should check? Looking for answers.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
