I am trying to plumb dedicated hydraulics to the loader. They will be removable with the loader like on modern tractors. With the 17 GPM, fresh oil, filters it MOVES! I am just limited on capacity by the stock #1600 relief and I have no additional remotes for rear implements. When I bale hay I have to disconnect one of the loader circuits or remove the loader. If I had a PTO pump and dedicated loader reservoir, I could not use a PTO implement with the loader installed. With the remotes controling the loader, I cannot use a rear remote for implement cylinders.
So... I am going the "dedicated loader directional control valve route". As much money as I have spent on rebuilding the ENTIRE system hydraulics, I am going to make it earn its keep. At this point a $300 valve, plus fittings and hose is not an issue. Next up when I decide to drop some more cash I will be contacting Rusty for a Schwartz.
I know this is a small tractor in the realms of a row crop tractor. But 50 hp with a loader, IPTO, and live hydraulics is all I will really ever need. Why not set it up right and it may last another 46 years. The biggest tractor we had on a 150 acre cattle farm growing up was a JD 3020. I just want a 6 cylinder for the next project! Maybe a Hydro, but definatly RED.
When I am done I can use the loader, the PTO, and the remotes without removing ANYTHING or at the SAME TIME (almost). Once all this is done, it is final oil leak repairs and paint time!
Once again I appriciate the patience you guys have... I tend to look too deep into things sometimes. But in this case I could trash a new pump if I plumb this incorrectly.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.