Posted by Bob S. on August 10, 2008 at 16:26:22 from (68.113.237.237):
I know the same questions get asked every day of the week but I need to know for sure before rewiring. My 51 M was converted to 12V and tuned up before I bought it 2mo. ago, it starts and runs good but doesnt charge ( not a big deal right now because I still have 2 dozen things to fix on it before I start using it ) all I was going to do was put some wire ends on ( cant stand that twisted ends wiring ). I had copied a wiring diagram off this site a while back and thought I would double check my wiring, at first it all looked good but then I noticed the wires on the coil were oposite of the diagram . On mine the wire goes from ignition switch to -side of coil and +side to dist. Battery is neg ground. System has the ballast resistor and little bulb in line. Apreciate any advice ( about my wiring that is ) Thanks Bob S.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.