Posted by GordoSD on August 10, 2008 at 08:39:08 from (66.115.200.140):
Getting near the end of my SMTA resto. Steering pedestal, shafts, lightbar, lights, governor lever,and steering wheel installed last night. This is the second wheel I have installed as I am also finishing an H.
Both of the wheels were new repros. And both were a bear to get on the shaft. Of course I had them both painted red. They are just too small inside diameter. They start on OK then get increasingly tighter. By the time you figure this out it's too late to get it off without ruining the paint.You have to get a deep socket, bfh, and ruin the paint in the process. NEXT TIME, I will test fit prior to painting.Ream/hone that wheel out so it slides on with moderate pressure. The keyway will keep it from turning.I just pray I don't ever have to try and get those two steering wheels off these tractors.
Just a tip to you all who are going to install new wheels.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.