The transmissions on thess tractors are not synchromeshed, so they tend to be a little noisy anyway.
You may have a problem, but try this first. You'll need a helper, who need not have any mechanical knowledge or aptitude. Start the tractor with the PTO engaged. With the tractor running step on the clutch for several seconds. Have your helper tell you whether or not the PTO shaft is turning. If it is, try slipping or grinding it into gear. No need to move the tractor. If the PTO was turning, it should stop once you have the tractor in gear and not moving. Then slip the tractor back out of gear with the PTO till engaged. It may or may not start turning again.
As I said, you would normally have to hold the clutch down for a fewswconds to get it into gerar from a stop without grinding anyway. That's to give the shaft time to spin down to a stop. If the PTO is turning pretty freely, though, a good chance that your pilot bushing is gummed up. The front of the driveshaft is held on center by that bushing and as it accumulates gunk, it can bind enough to keep the shaft spinning some, thopugh not with any power to it, just enough to make the gears turn and be noisy as you shift into gear.
That said, it wouldn't hurt to check the freeplay on your lutch pedal, just to make sure it's releasing enough. Free play should be as close to 1-7/16" as you can get it, measured from the front ege of the deck. Adjustment is made with the clevis at the front of the rod you'll find lower down on the pedal arm.
If adjusting the freeplay doesn't fix it or at least make it better, it will almost certainly be the pilot bushing. If you can live with it, I'd wait until I had another reason to split the tractor, as that is required to get to that bushing. It's nested in the center of the rear of the crankshaft.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
