Can't say for sure what it was on the F-series, but it was pretty much standard for the letter series, except for the very earlies ones, and certainly was standard in '47.
Two types.
For the magneto-fired tractors, it was a single pole switch with a wire running to the side of the mag. With the button down, the mag was grounded, keeping the tractor from running and stopping it if it was. With the button up, it broke the connection to ground leaving the mag free to fire the plugs. The earliest As and Bs (and maybe the Hs and Ms --not sure of that) had a lever that ran forward to mechanically ground the mag to kill the engine. The switch replaced that setup.
On battery ignitions, it was a two-pole switch. Up, it completed the circuit to provide juice to the coil so it could fire. Down, it broke that connection.
The switch cases and buttons look pretty much alike. The difference is in their guts and function.
The originals and reproductions read OUT --RUN/IN --STOP on top of the button.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Allis-Chalmers Model G - by Staff. The first Allis-Chalmers Model G was produced in 1948 in Gasden, Alabama, and was designed for vegetable gardeners, small farms and landscape businesses. It is a small compact tractor that came with a complete line of implements especially tailored for its unique design. It featured a rear-mounted Continental N62 four-cylinder engine with a 2-3/8 x 3-1/2 inch bore and stroke. The rear-mounted engine provided traction for the rear wheels while at the same time gave the tractor operator a gre
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
