Farmall & IHC Tractors Discussion Board |
Super A plow alignment? Hickupping Hydraulics????
[ View Follow Ups ] [ Post Followup ] [ Return to Farmall & IHC Tractors Discussion Board ]
Posted by p on March 18, 2000 at 22:53:39 from (205.188.197.162):
I installed the molboard plow on my Super A today. I swithched the drawbar, I don't have the draft control bar so I used a chain. As I attached the plow to the drawbar I began to contemplate a few problems. The biggest is where do I bolt it to the drawbar. Above or below, and in which set of holes. I put it on top of the drawbar and as far right(if in drivers seat) as it could go. Is this correct? Also, I forgot about the hydraulics, they work fine but when I put a load on them and leave them to support it they slowly sag and then quickly recover. This leaves what I call a hickup. it is up, the plow sinks about an inch and it bounces back up???? can this be adjusted out, (it has been like this for the 15 or so years we owned it but I have not had anything on the hyrdaulics in years. Thanks for ANY info...p
Follow Ups:
Home
| Forums
Today's Featured Article -
Box Plow Blues - by Tom Schwarz. One of the first implements most tractor owners obtain is the box plow. For very little money, this piece of equipment promises to plow and flatten any hill or vale on your ranch road or farm. At least that's what I thought! As simple as a box plow appears, it can be rather challenging to make work correctly. In our sandy soils of Florida, traction is king. You can never have wide enough tires or heavy enough weights to get all the traction you want … unless you own a monster tractor. U
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|