I reworked the axle housing seals on my F504 last year, they were leaking bad. I believe the original gaskets were in place from 1962. I took a different approach to my job due to the facilities and equipment I had available at my father's shop on the farm.
We removed the IPTO housing to access the bull gears and pulled them off. We supported the tractor by a sling with a chain hoist on a trolley and I-Beam. There is also another I-beam perpendicular to the other and used another chain hoist to sling around the wheel. We removed the axle housing, LOADED 13.8x38 tire rim and cast iron wheel as one! Cleaned with brake clean and used Three Bond Sag Type Silicone (Japanese, best you will ever use) to make the gasket. No leaks after a year.
I think you will be good for a long time. Just watch out for the correct police! Just be careful using silicone as a gasket maker. A small amount of silicone or teflon tape breaks off in the hydraulic reservoir and you are about to witness a bad experience.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
