Hi, I resently purchased a SMD. It started hard and with a lot of black smoke, but it took a lot of cranking. I was new to the MD, so I first read and studied the shop manual. I decided to do everything I could first before taking anything apart. I found the Carb bowl had a lot of debree ,I then removed and cleaned Gas line and bowl. Removed screen at carb input, and it was full of debree. reinstalled and put measured amount of gum out in a full gas tank started and run it through till empty, repeated again. engine started better, but not smooth. Installed new points, dist. cap and wires, plugs looked near new. Engine would then start and run smooth after 6 to 8 turns and with little smoke. I pull choke out full for a couple of turns, push in and it starts a few turns later. Note: Always run on gas before shutting down, this cools the eng. and also burns out any remaining diesel. Don"t forget to throw the lever back to diesel after engine stops to cool starting valve seats. Brissco
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.