Posted by Owen Aaland on July 23, 2008 at 06:58:26 from (65.161.86.52):
Clefus said: (quoted from post at 18:07:07 07/21/08) I finally got a free moment yesterday to pull the head....
......Funny this head gasket only lasted less than 100 hours ....It was done before I got the tractor...I noticed some valves werent IH..also..just replacements....
Premature failure of the head gasket can be caused by a warped cylinder head, a warped block, improper sleeve height, or failed head bolts.
A stretched bolt can still be brought up to torque but will have lost enough strength so that it does not have the proper clamping force. When that happens they allow the head to move up when there is a power stroke in the cylinder. Any bolts that were looser than others when you took it apart need to be examined very closely for this problem.
Adjust the valves to specs given for the hot setting. That is fine for anything above room temperature.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Niagra View Mobile - Powered by a 1959 Ford Tractor - by Mark Massey. In 1959 the Niagara Frontier Transit Inc. of Buffalo, New York designed and built six Viewmobiles for the Niagara Frontier Sightseeing Inc. for use as a sightseeing ride at the Niagara Falls State Park, Niagara Falls, New York, powered by a 1959 Ford 611 Tractor.
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.