Jim: I've never done one of these on a touch control system. I did have a two spool valve with power beyond on my Farmall 300. It took it's power from the high pressure line coming from pump. The return of the power beyond valve went back into the high pressure line going to, and to power 300s regular 3 spool valve system.
I have been planing for some time to install something similar on my 130. On the 300 room for all this plumbing was not an issue, however with 130 it is an issue. I want this to be tidy. Currently my fabricated snow blade is lifted by rockshaft quite similar to the factory blade, however my blade is much heavier, and I'd far sooner be using a remote cylinder.
I've seen several systems or plumbing arangements on tractors with touch control, however no one has been able to tell me which is best. My own impression is that a factory remote valve and manifold, the type used on SC or 200 fast hitch, would be the best. I don't like the small elbos I've seen, screwed into manifold above the clutch pedal. I've got big feet. From your post, I assume, even with the block between manifold and touch control, one still has an elbo on right side of manifold. Correct me if I've misread you.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.