Karl: Aside from what Jim has said, one needs to know how the plumbing is done. I presume the added reservoir is either coupled to fill or drain plug and has a breather added on top, right or wrong?
Where is the Gressen valve plumbed into system? To work it must have a pressure supply from the tractor system and it must also have a return line back to the system. Beyond that there must be ports for cylinder supply, one will be single action, two will be double action.
Most of these received the pressure supply from a block spacer about 1/2" to 3/4" thick and bolted between hydraulic manifold from pump and the touch control unit. That block has a port for pressure supply to the valve. The return line just has to return oil to the reservoir, during the time your not activating the valve, probably somewhere between 80 and 98 percent of the time tractor is running.
I've also seen these plumbed several other ways, one being a power beyond valve with it's own pressure control and plumbed into high pressure line from pump and the return line from valve putting pressure to touch control system.
Any way this is achived, one must have a pressure line from the system and a return line back to the system. Oil must go somewhere during times the valve is not activated and supplying oil to cylinder or cylinders.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.