I guess A #46 IH baler is much smaller than a New holland 273 because 35 hp sounds very little to be running a baler. Maybe without a wagon 35 hp would do it for a #46. Neighbor had a 1965 Ford 4000 (must've been one of the first with the new paint & sheet metal) on a 273 with a 16 ft. wagon and it could hardly handle it. Even with Grandpas' Massey 165 diesel (52 hp) the same outfit kept the tractor working hard. You've got to figure in, as mentioned, hilly fields, and also if its thick (1st cutting always is) or damp hay. A smaller baler may be be prone to plugging up more in thick hay, especially without enough horsepower, so enough hp is crucial. I would say a 400 Farmall minimum. A 450 would be better. If I remember right the 400 was kind of a replacement of the M and a 450 is an updated 400, so thats really top of the line with that era of tractors. I think someone said 1963 or newer. Not a bad idea. A 544 or 656 would get the job done well (much more expensive that a 400 or 450). There are a number of options if you look at a few other colors too (Massey 165, 175; Oliver 1550, 1650; Allis-Chalmers D-17). Again, more expensive. Depends on the $ you have to work with. $1000 won't buy much. $1500 may buy a good 400 Farmall or a WD-45 Allis in some places. Hope I didn't confuse anybody too bad.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
