That yoke threads off ! I believe it is a left hand thread.
Take a old 1/2 drive socket and weld a piece of key stock accross it that is the same width as the slot on the yoke. You may get lucky width a "good" impact gun but you will probaly end up with a big pry bar.
Tractor in gear, there is horror stories on the removal of this yoke. If your going to drain the trans a little heat might not hurt. I got lucky with a impact and it came right off.
The orignal seal is a twin lip leather one. The new ones are single lip, put this new seal inbetween the ware marks of the orignal seal.
The new seal will be thinner and take up much less space, make sure you put the sealing surface on a area of the shaft that doesn't have a ware mark .
This wasn't a bad job for me i got lucky . Use a old impact socket and weld the hell out of it.
What i told you hear is what the I.H dealer had me do and it works perfect "ZERO" leaks .
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: Repairin a Gas Tank - by Staff. This interesting discussion is from the Tool Talk Discussion Forum. Remember that safety is your first priority - make sure you know what you are doing before attempting a potentially dangerous activity!
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
