> I think the correct bolts have holes that let > oil go from yhe gallery to the rocker stand.
None of the bolts are drilled (and it was oiling ok last year when I adjusted the rockers). I have the rocker assembly apart and can see the oil holes in the 1st and 3rd rocker stands and the shaft: it's clear that the oil is to come up in the clearance around the bolts (or if it isn't I don't see how it could work).
> Your owners manual will have a lubrication > diagram.
The engine shop manual has a diagram showing that the cam bearings distribute oil to the rockers and the governor but does not detail the route to the rockers.
> I thought it was the middle stand.
The first and the middle stand are drilled with oil ports opening to the shaft. The shaft has a matching hole for the port in the first stand but not for the middle one. Possibly the middle stand does not actually carry any oil despite being drilled.
Perhaps the camshaft bearing is so worn that the oil all leaks out without developing enough pressure at that point to reach the rockers. But if that is true why didn't the oil I poured into the holes drain away quickly?
Perhaps the camshaft oil gallery is clogged. But if so, why do I see lots of oil on the cam followers?
I'm reluctant to spend $275 and a lot of labor on a reman cam until I know what is going on. I'd hate to put that cam in and then need an engine anyway.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.